收藏本站
123
8018P–AVR–08/10
ATmega169P
The Timer/Counter Overflow Flag (TOV1) is set each time the counter reaches BOTTOM. When
either OCR1A or ICR1 is used for defining the TOP value, the OC1A or ICF1 Flag is set accord-
ingly at the same timer clock cycle as the OCR1x Registers are updated with the double buffer
value (at TOP). The Interrupt Flags can be used to generate an interrupt each time the counter
reaches the TOP or BOTTOM value.
When changing the TOP value the program must ensure that the new TOP value is higher or
equal to the value of all of the Compare Registers. If the TOP value is lower than any of the
Compare Registers, a compare match will never occur between the TCNT1 and the OCR1x.
Note that when using fixed TOP values, the unused bits are masked to zero when any of the
OCR1x Registers are written. As the third period shown in Figure 15-8 on page 122 illustrates,
changing the TOP actively while the Timer/Counter is running in the phase correct mode can
result in an unsymmetrical output. The reason for this can be found in the time of update of the
OCR1x Register. Since the OCR1x update occurs at TOP, the PWM period starts and ends at
TOP. This implies that the length of the falling slope is determined by the previous TOP value,
while the length of the rising slope is determined by the new TOP value. When these two values
differ the two slopes of the period will differ in length. The difference in length gives the unsym-
metrical result on the output.
It is recommended to use the phase and frequency correct mode instead of the phase correct
mode when changing the TOP value while the Timer/Counter is running. When using a static
TOP value there are practically no differences between the two modes of operation.
In phase correct PWM mode, the compare units allow generation of PWM waveforms on the
OC1x pins. Setting the COM1x1:0 bits to two will produce a non-inverted PWM and an inverted
PWM output can be generated by setting the COM1x1:0 to three (See Table 15-3 on page 129).
The actual OC1x value will only be visible on the port pin if the data direction for the port pin is
set as output (DDR_OC1x). The PWM waveform is generated by setting (or clearing) the OC1x
Register at the compare match between OCR1x and TCNT1 when the counter increments, and
clearing (or setting) the OC1x Register at compare match between OCR1x and TCNT1 when
the counter decrements. The PWM frequency for the output when using phase correct PWM can
be calculated by the following equation:
The N variable represents the prescaler divider (1, 8, 64, 256, or 1024).
The extreme values for the OCR1x Register represent special cases when generating a PWM
waveform output in the phase correct PWM mode. If the OCR1x is set equal to BOTTOM the
output will be continuously low and if set equal to TOP the output will be continuously high for
non-inverted PWM mode. For inverted PWM the output will have the opposite logic values. If
OCR1A is used to define the TOP value (WGM13:0 = 11) and COM1A1:0 = 1, the OC1A output
will toggle with a 50% duty cycle.
fOCnxPCPWM
f
clk_I/O
2
NTOP
----------------------------
=
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
ATMEGA169P-16MCU MCU AVR 16K ISP FLSH 16MHZ 64QFN
AT91SAM7XC256-CU MCU ARM 256K HS FLASH 100-TFBGA
PIC16LF874A-I/P IC MCU FLASH 4KX14 EE A/D 40DIP
PIC16F84-10/SO IC MCU FLASH 1KX14 EE 18SOIC
AT91SAM7XC128-CU MCU ARM 128K HS FLASH 100-TFBGA
PIC18F2458-I/SO IC PIC MCU FLASH 12KX16 28SOIC
PIC18F4455-I/P IC PIC MCU FLASH 12KX16 40DIP
AT91SAM7X256-CU MCU ARM 256K HS FLASH 100-TFBGA
相关代理商/技术参数
ATMEGA169PV-8MU 功能描述:8位微控制器 -MCU AVR 16K FLASH 512B EE 1K SRAM 5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA169PV-8MU SL383 制造商:Atmel Corporation 功能描述:MCU 8BIT ATMEGA RISC 16KB FLASH 2.5V/3.3V/5V 64PIN MLF - Tape and Reel
ATMEGA169PV-8MU 制造商:Atmel Corporation 功能描述:IC 8BIT MCU AVR MEGA 8MHZ 64-QFN
ATMEGA169PV-8MUR 功能描述:8位微控制器 -MCU AVR LCD 16KB FLSH EE 512B 1KB SRAM-8MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA169V 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-bit Microcontroller with 16K Bytes In-System Programmable Flash
ATMEGA169V_06 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-bit Microcontroller with 16K Bytes In-System Programmable Flash
ATMEGA169V-1AC 功能描述:IC MCU 8BIT 16KB FLASH 64TQFP 制造商:microchip technology 系列:AVR? ATmega 包装:托盘 零件状态:停產 核心处理器:AVR 核心尺寸:8-位 速度:1MHz 连接性:SPI，UART/USART，USI 外设:欠压检测/复位，LCD，POR，PWM，WDT I/O 数:53 程序存储容量:16KB（8K x 16） 程序存储器类型:闪存 EEPROM 容量:512 x 8 RAM 容量:1K x 8 电压 - 电源（Vcc/Vdd）:1.8 V ~ 5.5 V 数据转换器:A/D 8x10b 振荡器类型:内部 工作温度:0°C ~ 70°C 封装/外壳:64-TQFP 供应商器件封装:64-TQFP（14x14） 基本零件编号:ATmega169 标准包装:160
ATMEGA169V-1AI 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-bit AVR Microcontroller with 16K Bytes In-System Programmable Flash